Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Arleta, CA
Chimney repair in Arleta usually means working on a 60-plus-year-old masonry fireplace that was built when this part of the San Fernando Valley was still transitioning from orchards to tract housing. The fireboxes are original brick, the flues are clay tile, and decades of dry Valley heat have done what dry heat does to mortar. We’re Chimney Sweep Northridge, and we’ve served Arleta since 2012. If you’re seeing loose brick, a damp chimney, or a cap that’s rusted through, call (833) 589-9223 and we’ll tell you exactly what’s going on.
Why Arleta Homes Are Different
Arleta’s housing stock is mostly mid-century single-family stucco, built between the 1940s and 1960s. The fireplaces in these homes aren’t factory units. They’re site-built masonry structures with open-hearth fireboxes, original clay-tile flues, and damper assemblies that are often older than the current homeowner. What that means in practice is this: when we open a chimney in Arleta, we expect to find mortar that has spalled from decades of thermal cycling, flue joints that have dried and separated, and interior brick that’s loose enough to wiggle by hand. That’s not a defect in the house. It’s what time and a semi-arid climate do to a chimney that was never designed for 60 years of use.
The other Arleta-specific factor is wind. Homes here sit near the Pacoima Wash and Tujunga Wash channels, and when Santa Ana winds come through, they push dust, grit, and debris straight into chimney caps and screens. We see caps packed with fine silt, screens partially blocked, and in some cases, caps that have been physically shifted by wind gusts. A chimney that drafts fine in September can behave differently by December if the cap is half-choked with wind-blown debris. Sweeping season here skews to late fall, before the first cold snaps, because that’s when the wind-driven loading is highest and the fireplaces start getting nightly use.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Main Arleta Services
Most Arleta homeowners call us for one of two reasons: they need the chimney swept before burning season, or they’ve noticed the dryer taking longer than it should and want the vent cleared before it becomes a fire hazard.
Chimney Sweep in Arleta
A chimney sweep in Arleta is rarely just a sweep. Given the age of the housing stock, our technicians are looking at clay-tile flues, old damper assemblies, and mortar joints that have been baking in Valley heat since before the 405 was finished. We remove the creosote and soot, yes, but we also inspect the firebox, the damper, the flue liner, and the cap, and we tell you what we found in plain language. If you’ve got loose brick or a deteriorated flue joint, you’ll know before the first fire of the season. See Chimney Sweep in Arleta for the full breakdown.
Dryer Vent Cleaning in Arleta
Dryer vents in Arleta collect the same wind-blown dust that chimney caps do, and in a mid-century tract house, the vent run is often longer than it should be, with a bend or two that traps lint. That lint is combustible, and it’s one of the leading causes of residential structure fires nationwide. We clear the full run, from the dryer to the exterior termination, and we check the hood and flap for wind damage. It’s a separate fire-safety system from your chimney, and it deserves the same attention. See Dryer Vent Cleaning in Arleta.
Chimney Repair in Arleta
Chimney repair in Arleta is, more often than not, masonry work on a chimney that’s been standing since the Eisenhower administration. The dry heat and decades of thermal cycling have done what they do: mortar joints spall, bricks loosen, flue tiles crack, and crowns develop hairline fractures that let water in. The most common thing we tell Arleta homeowners is that what looked like a routine sweep turned up loose interior brick and deteriorated flue joints, and the fix is more than cosmetic. It’s structural, and it protects the house from chimney fire and carbon monoxide. Our shop handles everything from cap replacement to full liner installation, using parts from brands like Gelco, Olympia Chimney, and Famco, not whatever the big-box store had on the shelf. For the full scope of our repair capabilities, see Chimney Repair.
Chimney Cap Installation
Signs you need it
You’re seeing water or debris inside the firebox, or birds and rodents are getting into the flue.
What it costs in Arleta
Chimney cap installation in Arleta typically runs $300 to $700 depending on the flue size and the cap material.
How we do it
We measure the flue, select a cap from our stocked Famco or Olympia Chimney inventory, and secure it so Santa Ana gusts can’t shift it.
Chimney Cap Replacement
Signs you need it
Your existing cap is rusted through, bent out of shape, or missing entirely.
What it costs in Arleta
Chimney cap replacement in Arleta typically costs $350 to $800, with the higher end covering custom-fit caps for older clay-tile flues.
How we do it
We remove the old cap, check the flue crown underneath for damage, and install a replacement sized to the flue’s exact inside diameter.
Chimney Liner Installation
Signs you need it
Your clay-tile flue is cracked, spalled, or missing sections, and exhaust gases are leaking into the wall cavity or living space.
What it costs in Arleta
Chimney liner installation in Arleta typically runs $2,500 to $5,000 depending on the flue height and whether we’re working with DuraFlex stainless steel or a HeatShield resurfacing alternative.
How we do it
We size the liner to the appliance and flue, run it from the firebox to the crown, and secure the top plate and cap so the system drafts correctly.
Chimney Flashing Repair
Signs you need it
You have water staining on the ceiling or walls near the chimney, or you can see cracked caulk and lifted metal at the roofline.
What it costs in Arleta
Chimney flashing repair in Arleta typically runs $300 to $700, and it’s one of the cheapest ways to prevent a much more expensive masonry rebuild.
How we do it
We remove the old flashing, inspect the surrounding mortar and deck, and install new step and counter flashing from Copperfield with a proper seal.
Chimney Crown Repair
Signs you need it
The concrete crown at the top of your chimney is cracked, crumbling, or missing pieces, and water is getting into the structure.
What it costs in Arleta
Chimney crown repair in Arleta typically runs $600 to $1,500 depending on how much of the old crown needs to be removed and recast.
How we do it
We chip out the damaged crown, form and pour a new one with a proper drip edge, and seal it so water sheds away from the flue.
What Chimney Repair Costs in Arleta
| Item | Typical range in Arleta |
|---|---|
| Chimney cap installation | $300 – $700 |
| Chimney cap replacement | $350 – $800 |
| Chimney flashing repair | $300 – $700 |
| Chimney crown repair | $600 – $1,500 |
| Chimney liner installation | $2,500 – $5,000 |
How long does chimney repair take in Arleta?
Most cap, flashing, and crown repairs are done in a single visit, usually three to five hours. A full liner installation is a full day. If we find additional masonry damage, we’ll tell you before we do anything, with photos so you can see it yourself.
Do I really need to repair my chimney before I use it?
If the flue liner is cracked or the firebox has loose brick, yes. Those are the conditions that let chimney fires start and carbon monoxide enter the house. A sweep clears the path, but it doesn’t fix a broken path. Call (833) 589-9223 for an honest assessment.
Brands We Service in Arleta
We stock and install parts from Gelco, Olympia Chimney, Famco, and Copperfield. That means when your Arleta home needs a new cap or flashing, the part is on the truck, not ordered from a catalog and rescheduled two weeks out. See our brands for the full lineup.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Arleta, CA
| Service | Typical range in Arleta |
|---|---|
| Chimney sweep | $149 – $229 |
| Chimney inspection | $99 – $199 |
| Dryer vent cleaning | $99 – $149 |
| Chimney cap installation | $300 – $700 |
| Chimney cap replacement | $350 – $800 |
| Chimney flashing repair | $300 – $700 |
| Chimney crown repair | $600 – $1,500 |
| Chimney liner installation | $2,500 – $5,000 |
What pushes the price up in Arleta is the age of the structure. A 60-year-old clay-tile flue with spalled mortar needs more prep work than a newer chimney, and wind damage to flashing and caps is common near the wash channels. Whatever the quote is, it’s a flat price agreed before the work starts, based on what we see with the camera, not a guess.
Neighborhoods We Serve in Arleta
Our service area covers all of Arleta’s 91331 ZIP code, from the residential blocks east of the Pacoima Wash to the streets bordering Panorama City and Sun Valley. We’re typically in the area within a week of your call, and sooner during the fall sweep season.
- Central Arleta
- Arleta north of Osborne Street
- Arleta near Canterbury Avenue
- Arleta adjacent to Branford Park
- Arleta east of the Pacoima Wash
Service Area – Cities Near Arleta
We also handle chimney work in the surrounding San Fernando Valley communities, including Pacoima, CA, San Fernando, CA, Mission Hills, CA, and Panorama City, CA. If you’re in one of those areas, the same crew and the same brands apply.
Serving Arleta, CA – Our Local Coverage Area
We’re based in the Arleta area and know this community well. Use the map below to see our service coverage – if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Arleta
For most chimney sweeps and repairs we can schedule within a week. During the late-fall rush before the first cold snap, it’s tighter, so calling in September or early October gets you a better slot. Estimate visits are free, and we’ll give you the price before any work begins.
Most cap, flashing, and crown repairs don’t require a permit because they’re considered maintenance on the existing structure. A full liner installation may, depending on the scope, and we’ll tell you if that applies to your job. We handle the paperwork when it does.
Creosote keeps building, and over time it becomes the fuel for a chimney fire. Meanwhile, a cracked liner or loose brick lets heat and gases go where they shouldn’t. The damage compounds, and the repair bill gets bigger. Call (833) 589-9223 and we’ll tell you plainly what your chimney needs and what can safely wait.
What happens when you call
- 1A real person answersNo phone trees. Talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you. The visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Arleta Customers Say
"Crown was cracked and taking water. Repaired it rather than quoting a rebuild, which the previous company had pushed hard for."
- Marcus Boyd"Good work. The written inspection report took about a week to arrive after I asked for it, which was slower than I expected."
- Nathan Whitaker"Thorough sweep and a clear report. He was running late from the job before and arrived near the end of the window, though he did call to warn me."
- Chris Meyer